Designed to enhance any serious operators shack, this rack-mounted unit offers exceptional sound quality and large, easy-to-use controls. The RCI-2995DX has features that include: AM-CW-FM-SSB modes of operation, variable power, noise blanker and built-in heavy duty AC power supply and provides 150 watts PEP output, and a rear panel frequency meter output for measuring transmit operating frequency.

Dual panel meters display received signal strength transmitter power output and antenna SWR. Clarifier audio tone controls for accurate receiver tuning improved reception under difficult conditions. Pushbutton selection of programming scanning functions, and programmable repeater split for FM operation enhances the renewed 10 meter repeater activity.

The RCI-2995DX offers microprocessor-based advanced features typically found in high-end units costing several times as much, including programmable repeater offset and capabilities for a CTCSS tone option — great for increasing repeater activity on 10 meters — and receiver scanning for quick search of active frequencies. The unit offers three methods of frequency selection, non-volatile memory to store and scan up to ten favorite frequencies, scanning of selected frequency segment or stored frequenciesand front panel frequency selector lockout .

In addition, the RCI-2995DX offers an impressive array of design and performance improvements:

—  An improved receiver: designed for increased sensitivity and image rejections.

—  A double FET balanced mixer: for improved receiver intermodulation rejection.

—  Surface mount components: for increased resistance to shock and vibration.

—  Variable Power Output from 150 watts to 2 watts - great for PSK-31 operation.

Tone Wiring
For complete instructions on wiring a CTCSS tone board into the RCI-2995DX, please click here: CTCSS.


For a side-by-side features comparison chart of the RCI-2995DX versus the other Ranger amateur models, please see the Comparison Chart.

RCI-2995DX Specifications

General	RCI-2995DX
Frequency Range	10 Mtr: 28.000 - 29.6999 MHz 12 Mtr: 24.8900 - 24.9900 MHz
Tuning Steps	1 MHz, 100 KHz, 10 KHz, 1 KHz, 100 Hz
Emission	USB, LSB, CW, AM, FM
Clarifier Range	±5 KHz
Frequency Tolerance	0.005%
Frequency Stability	0.001%
Operating Temperature Range	- 20 ºC to + 50 ºC
Meters	Left: RX Signal Strength Right: RF Output, Antenna SWR
Antenna Impedance	50 W
Input Voltage	110 VAC, 60 Hz ( 220 VAC, 50 Hz Optional )
AC Power Consumptions	300 Watts
Microphone	400 W Dynamic PTT - 6 Pin
Size (W x D x H)	19" x 12" x 6-1/4"
Weight	32 lb 6 oz
Shipping Weight	38 lb.
Transmitter
RF Power Output	50 Watts RMS: CW / AM / FM 150 Watts (PEP): SSB
Modes	USB, LSB, CW, AM, FM
Carrier Suppression	Better Than 60 dB
Spurious Emission	More Than 60 dB
Antenna Connector	Standard SO-239 Type
Output Impedance	Unbalanced 50 W
Receiver
Sensitivity	AM / CW: 0.7 µV for 10 db SINAD FM: 0.5 µV for 12 db SINAD SSB: 0.2 µV for 10 db SINAD
AM / FM Selectivity	50 db at 10 KHz
SSB Selectivity	5 db at 2 KHz, 60 db at 4 KHz
Image Rejection	More than 50 db
IF Rejection	More than 80 db at 455 KHz
Audio Output Power	2.5 Watts @ 10% THD
Intermod Rejection	> 50 db
Noise Blanker	IF Single Gate Type
Built In Speaker	8 W
External Speaker	Disables Internal Speaker When Connected, 8 W

NOTE:
The RCI line of Ranger products are not available factory direct.
Please contact your favorite dealer for these products.